Setting up nameservers in Plesk
Posted by - NA -, Last modified by Kevin Stange on 03 November 2010 04:32 PM
|
This article explains how to configure Plesk to host the following two nameservers:
ns1.nsdomain.com
ns2.nsdomain.com
- Click Domains in the navigational bar on the left.
- Click on the domain you would like to setup the nameserver under (e.g. nsdomain.com)
- In the Services section, click DNS.
- In Add a DNS Record, choose NS for record type, and click "Add".
- Leave the entry for domain name blank, and enter the name of the first nameserver (e.g. ns1.nsdomain.com). Click OK.
- Repeat steps 4 and 5 for the second nameserver (e.g. ns2.nsdomain.com).
- In Add a DNS Record, choose A for record type, and click "Add".
- In domain name, enter the subdomain of the first nameserver (e.g. ns1) in the blank, and enter the IP you are assigning to this nameserver in the 4 blanks for the IP address. Click OK.
- Repeat steps 7 and 8 for the second nameserver.
- Click "Home" on the left navigation bar.
- In the Server section, click "DNS Settings."
- Check the box in the line with the NS record. Click "Remove".
- Check the box to confirm removal. Click OK.
- In Add a DNS Record, select NS for record type, and click "Add".
- Leave the entry for domain name blank, and enter the name of the first nameserver (e.g. ns1.nsdomain.com). Click OK.
- Repeat steps 14 and 15 for the second nameserver (e.g. ns2.nsdomain.com).
- At this point, the nameservers are configured on your server, and you will need to register the nameservers with your domain registrar. Please refer to your domain registrar for further instructions on how to do this.
|
(283 vote(s))
Helpful Not helpful
|